Mounting instructions:
Push-through mounting
- Drill and clean the drill hole
- Insert dowel through component into drill hole
- Drive the pin in flush
- Check the installation result
Installation must be carried out in accordance with the approval!
Areas of application:
The use of the ceiling nail is limited to the multiple fixing of non-load-bearing systems in concrete: anchoring with European Technical Approval in cracked concrete (concrete tension zone) and in non-cracked concrete (concrete compression zone).
The following therefore applies to fixings with the ceiling nail:
the anchor may be used, with European Technical Approval, in reinforced or unreinforced normal weight concrete with a strength class of at least C20/25 and at most C50/60 in accordance with EN 206-1:2000-12
the ceiling nail may only be used under dry indoor conditions
suitable for anchoring under predominantly static (e.g. dead weight, equipment, storage materials) or quasi-static (e.g. façade, railings) loads
can be used for fastening lightweight ceiling panelling and suspended ceilings, metal profiles, perforated strips, nonius hangers, wooden strips, wooden battens, squared timber, etc.
Am Bahnhof 50
74638
Waldenburg D
07942/100-0
bestellungen@swg.de
| Article type: | Ceiling nail |
|---|---|
| Assembly technology: | Striking & spreading |
| Brand: | SWG |
| Contents (st): | 100 |
| Diameter (mm): | 6 |
| Dowel/anchor with edge: | true |
| Drill-Ø (mm): | 6 |
| Drill hole depth min (mm): | 35 |
| Length (mm): | 35 |
| Manufacturer: | SWG |
| Manufacturer designation: | Ceiling nail |
| Material dowel & anchor: | Galvanised steel |
| Test mark: | ETA approval |
| Hersteller |
0 of 0 reviews
Average rating of 0 out of 5 stars
Login
SWG ceiling nail DN 6x35 - 100 pieces
